Software Downloads for ProtoTRAK Edge3
For ProtoTRAK models:
TRAK DPM E2
This process is for ProtoTRAK Edge3 System
software.
CNC upgrades to a new Windows® version of ProtoTRAK are available for
many ProtoTRAK CNCs. Ask your sales representative for more details.
Downloading the system software.
This process will download software for the ProtoTRAK system. The
instructions are written for downloads using computers with Windows 95
or above.
1. Click on the Download Now button.
2. In the selection window, select Save
Note: If you Open or Run instead of Save, the program
will attempt to write to your floppy drive
as described in Extraction Step 3 listed below - this
is not recommended.
3. Choose a location to save the file. You may want to create a
directory called "ProtoTRAK
Downloads" or save the file to your Desktop.
4. After the download completes, you will have the software saved
on your hard drive.
Close the download window if it is still open.
5. The software you have just downloaded is compressed to make it
easy to download. See the
instructions below "Extracting and installing the
software on your ProtoTRAK" to finish the process.
Extracting and installing the software on your
ProtoTRAK
This section describes the easiest way to get the software you have
downloaded from your computer
hard drive to your ProtoTRAK. The file you downloaded is a
self-extracting file for use with Windows 95 or above.
1. Place a formatted, blank floppy disk into your computer's
floppy drive (Drive A).
2. Locate the software you downloaded.
3. Double click the file.
This will cause the software to automatically copy the
correct files to the floppy disk you put
into Drive A.
4. When the process is completed, your new ProtoTRAK system disk
will be ready for use.
