Software Downloads for previous models of ProtoTRAK

For ProtoTRAK models:
ProtoTRAK MX2
ProtoTRAK MX3
TRAK AGE2
TRAK AGE3
ProtoTRAK M2
ProtoTRAK M3
ProtoTRAK LX2
ProtoTRAK LX3
ProtoTRAK SM and SL
ProtoTRAK VM and VL
TRAK QMV
ProtoTRAK EDGE
ProtoTRAK EDGE3

This process is for ProtoTRAK and TRAK CNC System software. If you were instructed to download slave software (this is infrequent) click here for slave software download.

CNC upgrades to a new Windows® version of ProtoTRAK are available for many ProtoTRAK CNCs. Ask your sales representative for more details.

Downloading the system software.
This process will download software for the ProtoTRAK system. The instructions are written for downloads using computers with Windows 95 or above.

1.  Click on the Download Now button next to the appropriate software for your control.
2.  In the selection window, select Save
     Note: If you Open or Run instead of Save, the program will attempt to write to your floppy drive
     as described in Extraction Step 3 listed below - this is not recommended.
3.  Choose a location to save the file. You may want to create a directory called "ProtoTRAK
     Downloads" or save the file to your Desktop.
4.  After the download completes, you will have the software saved on your hard drive.
     Close the download window if it is still open.
5.  The software you have just downloaded is compressed to make it easy to download. See the
     instructions below "Extracting and installing the software on your ProtoTRAK" to finish the process.

Extracting and installing the software on your ProtoTRAK
This section describes the easiest way to get the software you have downloaded from your computer
hard drive to your ProtoTRAK. The file you downloaded is a self-extracting file for use with Windows 95 or above.

1.  Place a formatted, blank floppy disk into your computer's floppy drive (Drive A).
2.  Locate the software you downloaded.
3.  Double click the file.
     This will cause the software to automatically copy the correct files to the floppy disk you put
     into Drive A.
4.  When the process is completed, your new ProtoTRAK system disk will be ready for use.