|
Software Downloads
|
| Current versions in this release: | 1.04 Floppy |
| 3.1 Slave |
This process is for ProtoTRAK Edge System
software.
Download Instructions
(For Windows 95 or above.)
1.
Click on the Download Now button
2. In the selection window, select Save
Note: If you Open or Run instead of Save, the program
will attempt to write to your floppy drive
as described in Extraction Step 3 listed below - this
is not recommended.
3. Choose a location to save the file. You may want to create a
directory called "ProtoTRAK
Downloads" or save the file to your Desktop.
4. After the download completes, you will have the software
saved on your hard drive.
Close the download window if it is still open.
5. The software you have just downloaded is compressed to make
it easy to download. See the
instructions below "Extracting and installing the
software on your ProtoTRAK" to finish the
process.
|
edge_104.exe 743 KB |
|
Extracting and installing the software on your ProtoTRAK
This section describes the easiest way to get the software you have
downloaded from your computer hard drive
to your ProtoTRAK. The file you downloaded
is a self-extracting file for use with Windows 95 or above.
1. Place a formatted, blank floppy disk into your computer's
floppy drive (Drive A).
2. Locate the software you downloaded.
3. Double click the file.
This will cause the software to automatically copy the
correct files to the floppy disk you put
into Drive A.
4. When the process is completed, your new ProtoTRAK system disk
will be ready for use with a default
calibration / configuration file.
5. To transfer an existing calibration / configuration, follow the
steps below:
a) Have the control booted with the original
system disk,
b) Insert the new system disk into the floppy
drive while the control is still powered on,
c) Run a service code 142 (DRO => SERV CODES =>
142, ABS SET). This will copy the existing
calibration /
configuration over to the new disk,
d) Reboot the Edge control with the new system
disk.